Monohull System Shown for illustration only, always use hot dipped galvanized shackles and seize the pins with monel wire per Colligo Marine guidelines. Shown with anchors placed at 120 degrees from each other and with the system hanging about 5 feet below the boat, in the water.

If you are placing your boat on an anchoring system in preparation for a storm, then this product is for you. It allows you to place 3 anchors and couple them together with a swivel and then run two or three lines back to your monohull or multihull boat, respectively. The boat can then swivel on the anchors without getting the anchor chains twisted around each other. We recommend running chain from your anchors to the system and then nylon lines to your boat.

The system includes 2 hot dipped galvanized plates with the usual > 4 mils zinc plating, 5 or 6, 5/8 inch hot dipped galvanized shackles and a 3/4 inch hot dipped galvanized swivel. All pull tested to our rigorous quality standards. The minimum breaking strength is over 30,000 lbs for the entire system!

• «« Start
• « Prev
• 1
• Next »
• End »»