Standard Terminator® Fittings

CSS74.jpg
CSS71.JPG
CSS72.JPG
CSS73_3.JPG
CSS74.jpg
CSS71.JPG
CSS72.JPG
CSS73_3.JPG

Standard Terminator® Fittings

from 66.61

Read below for technical info.

Size:
Quantity:
Add To Cart

About Line Terminators

Our Patented Line Terminator end fittings are the only spliceable, lashable, and pinable end fittings available that meet Hampidjan's recommended minimum 5/1 bending ratio for Colligo Dux. This is essential for long term durabilty of Dyneema based lines, as tight bending radii cause compressive stresses that weaken the line considerably. 

Larger sizes available for up to 23 mm line and custom sizes beyond that.

Note: Some pin size flexibility is designed into these parts - meaning, you can always go slightly smaller if you're in between sizes. Indicate your custom size in the 'Additional Notes' section during checkout.

Click here for our Line Terminator® Fittings Sizing Chart (printable)
U.S. Patent No. 8201309 B1



Terminator® Fittings Sizing Chart


Terminator® Fittings in Action


Video

CSS72


Related Hardware


Further Reading